John Lor
:dizzy2: 1987 300-e
I have been troubleshooting a "cold start" problem with my '87 300-e. The symtoms are 1. Takes multiple try's to start the engine. 2. Once the engine starts it runs as if it choking. it chugg's and if I press the accelerator the engine will quit. I have to let it chugg along for about a minute or two and only then can I rev the engine and drive. I was told that this problem could be cured by replacing the "cpld start valve". The dealer wanted 400.00 so I shoped around and found a "BORG/WARNER" cold start valve for 200.00. So I replaced it and I am having the same problem. Could the new valve be defective? Do I have to purchase one from the dealer? Can anyone give me some advise on what to try next? Thanks, John Lor |
IF you ve replaced the cold start valve take a look at some of the electronics.
Check your ovp and the warning harness to make sure thats good. It could be a faulty new cold start valve. Only way to find that out is take a know good one and put in there. |
John Lor 300-E cold start problem Canton GA
Thanks for the Input Oracle. I have fuel pressure going to the cold start valve. The wire harness appeares to be sound. I am not electricaly inclined so my next step will be to find a machanic with electric and fuel injector experiiance to trouble shoot the system.
|
I had a similar problem with a 190E 2.6 and it was hard to start and I bought a new ovp and it greatly improved the starting.
I can send you documents on how to test the electrical system on your car. Only takes a multimeter for the most of the tests. Send me your vin # and email addy so I can send it you. |
I would say it's a common problem when you have a defective fuel accumulator.
http://catalog.worldpac.com/mercedesshop/sophio/wizard.jsp?partner=mercedesshop&clientid=catalog.mercedesshop&baseurl=http://catalog.peachparts.com/&cookieid=26R0X2XXH26Y0U2FFP&year=1987&make=MB&model=300-E-002&category=All&part=Fuel+Accumulator If you installed a non-genuine cold start valve, I would strongly recommend that you replace it with the old original one. |
All times are GMT -4. The time now is 08:36 AM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2024 Pelican Parts, LLC - Posts may be archived for display on the Peach Parts or Pelican Parts Website