|
|
|
#1
|
|||
|
|||
I removed the drive shaft on my 1990 300CE.
I did not loosen the clamping nut-41 or 46mm wrench as I did not have one. I did mark the alignment between the front and rear shaft prior to removing it. While removed the rear disc and then gently pulled, the rear shaft seoperated from the front shaft. Does this mean that the clamping nut was tight enough? Apparently the rubber sleeve had cracks in it. I will replace the center bearing and rubber sleeve. What tools do I need to remove the center bearing? Do I need to tighten the clamping nut and who might have this wrench? Any suggestions would be helpful. Regards Barry |
Bookmarks |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
replacement drive shaft nuts and bolts | xp190 | Tech Help | 7 | 04-06-2003 10:25 PM |
240D Half Shaft question | will66 | Diesel Discussion | 3 | 11-27-2002 03:40 PM |
Question re failing rubber drive coupling/ water pump | B.Harrow | Vintage Mercedes Forum | 0 | 03-11-2002 01:38 PM |
560SEL bent drive shaft maybe?????? | Bzoo | Tech Help | 1 | 10-03-2001 02:16 PM |
Question of Flex disc for 1990 300CE-124 chassis | endeavor | Tech Help | 1 | 06-30-2001 05:31 PM |