Belt Slips
My Belts slips on my 92 400e under hard acceleration.
When it shifts 1-2 or 2-3 under hard acc.. it goes Sqeeek and the A/C compressor kicks off. It restarts after about 5 minutes or If i shut off and restart the car. I understand that there is a sensor that causes the shut off but whta can ultimately be done about the slipping. The tensioner setup is a joke. My V8 530i BMW has a seperate belt just for the A/C which probably prevents it from suffering the same fate. No Matter how much I tighten the tensioner, it still slips.(Until it breaks) I have 165K mi and just replaced both the belt and tensioner. The old tensioner Broke(mine only seem to last 30K mi/2years) and I decided what the hey and replaced the belt as well. I have it pretty tight yet it still slips. I dont want to break the new one. They're pricey at $230. HELP! |
Have you check the belt tension shock?
Is the rubber bushing and the spacer OK? I have to replace the tensioner once, and have remove the belt many times. But I never have any problem with the belt is not being able to tighten. jack |
There is no "shock" on the M.119 V8's. The tensioner is spring loaded. The tension comes from the internal resistance brought about by "tightening" the bolt. My BMW has a "spring" type tensioner. I just replaced the tensioner on it last month as well.
|
All times are GMT -4. The time now is 12:40 PM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2024 Pelican Parts, LLC - Posts may be archived for display on the Peach Parts or Pelican Parts Website