|
|
|
|
|
#1
05-12-2008, 08:18 AM
|
||||
|
||||
hard cold start repair easy fix
1989 230e had hard cold and hot starts check this before spending a lot cash on parts you may not need
remove air cleaner check cross bar on top of sencer plate remove from vehicle and see if it is bent if so the vehicle has had a back fire try to strightern crossbar (vise)etc now check if sencer plate is coming all the way back if not loosern 10 mil bolt and adjust sencer plate and moke sure there is no binding once you have done that tighten 10 mil bolt and refit crossbar start vehicle if it runs ok now adjust mixture run vehicle until it is hot remove black diaignos cap and check the voltage with amultimeter from number three and to earth the reading should be 6.9 to 7.2 mixture adjust all done refit air cleaner . 
|
|
#2
05-12-2008, 09:58 AM
|
|||
|
|||
|
Is it necessary to remove the center plate? or can it be done withit on the car?
Why a backfire disturbs center plate centering?
__________________
Keep us posted especially if your problem is solved Present cars: My car: E-class 420CDI, 2008, W211, V8, 180 000km Wife's one: C-class 220CDI Sport Coupé, Euro, 2002, W203. 345 000km Son's one: GLK class 220CDI, 2009, W204 Sold E class 260E, W124, 1988 beloved car sold after 489 000 kilometres of reliable services (engine M103, clutch and 5 speed manual gear box all original). E-class, W210 320CDI, 2000[/B], 225 000km, Sold Last edited by cc260E; 05-12-2008 at 10:10 AM.
|
|
#3
05-12-2008, 11:33 AM
|
||||
|
||||
|
hard cold start easy repair
no you dont have to take center plate off you have to take crossbar off to check if it is bent or not .
depends on the back fire when the center plate is down and a back fire happerns it rams it shut hard .
|
 |
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
