Quote:
Originally Posted by slk230red
I wish I had a simple answer, but all I can advise is going back over the basics.
1. Did you install the correct Vacuum Modulator for your car, mine is GREEN, I think yours should be RED.
2. Is the vacuum hose going to the Vacuum Modulator connected and not leaking.
3. If you do have the correct VM installed, it might need adjusting.
|
1. I did install a red one. I'm sure that is the one for my car.
2. I put a brand new hose and rubber connectors on each end.
3. I need to adjust the VM. However, I was under the impression that the VM controled the degree of the shift (hard or soft) whereas the Bowden cable controled the shift points. Am I wrong?
08-21-2008, 06:09 PM
Threaded Mode
