Parts Catalog Accessories Catalog How To Articles Tech Forums
Call Pelican Parts at 888-280-7799
Shopping Cart Cart | Project List | Order Status | Help



Go Back   PeachParts Mercedes-Benz Forum > Mercedes-Benz Tech Information and Support > Tech Help

Reply
 
LinkBack Thread Tools Display Modes
  #1  
Old 09-21-2008, 11:33 PM
Registered User
 
Join Date: Sep 2006
Posts: 10
Unhappy 98 SL500 Overheat No Power Only 3000rpm

So just bought a 1998 SL500 with 115k miles. Car can not go over 3000 rpm and has no power. The car would idle fine and be fine up to 2000 rpm can go higher than that up to 3000rpm but it will overheat. Now it does this in P, N or driving. When driving has almost no power. I did the spark plugs. It has M119 engine and the little plastic tubes by the cam that take oil to the lifter, three of them where broken so I replaced them. I haven't lost any water. The level hasn't changed. And I don't see water in oil. But I do see some smoke coming out of the oil dipstick and oil filler cap.

Also car does not blow cold (not even outside air) even when Climate control put to cold(A/C) in the interior. In the cabin it will always blow hot air. Not sure if these are related.

My guess is that I might have a badly clogged catalyc converter. This is what I did to test it since I could not remove any O2 sensors. I took out one of the spark plugs and run the engine for a few seconds. With one spark plug out the car would rev up to 4200 rpm.
So I am thinking my catalyc converter or muffler may be clogged really bad.
The check engine light is on and has cyl 2 and cyl 4 misfire code but the plugs are new from Mercedes Benz and I have switched the coils around to make sure it is not the coils. Still getting the spark plugs misfire code.

Now I do all this more as a hobby and I am not a mechanic so I wanted to ask for an experienced advice what you think? Have you seen this before?

Thank you and sorry for my English.

I only paid US $4000. Can't return it. I knew I was gambling.


Last edited by hilarushi; 09-22-2008 at 02:35 AM.
Reply With Quote
  #2  
Old 09-22-2008, 03:23 AM
bobs's Avatar
Registered User
 
Join Date: May 2007
Location: Richmond, VA
Posts: 310
If the A/C is blowing hot air all the time, it sounds like your duovalve is in need of a rebuild or replacement. Search for "duovalve" in this forum and will find lots of articles on the subject.
__________________
"It's not about how fast you can go, but how well you can go fast."

Bob in Richmond

'97 S320 (LWB), Ruby Red Metallic, 73k miles
'97 S420V, Smoke Silver Metallic, 155k miles
Reply With Quote
  #3  
Old 09-22-2008, 11:33 AM
JimF's Avatar
'94 S500: only 793 sold!
 
Join Date: Mar 2001
Location: San Diego, CA
Posts: 1,933
Quote:
Originally Posted by hilarushi View Post
My guess is that I might have a badly clogged catalyc converter. This is what I did to test it since I could not remove any O2 sensors. I took out one of the spark plugs and run the engine for a few seconds. With one spark plug out the car would rev up to 4200 rpm.
So I am thinking my catalyc converter or muffler may be clogged really bad.
Good call . . when you hit the pedal, does the engine/exhaust output sound strange?? If it does, you probably nailed the problem.
__________________
Regards . . . . JimF
-------------------
'94 S500 Cpe

Visit my Mercedes Web Page
Reply With Quote
  #4  
Old 09-22-2008, 11:35 AM
Registered User
 
Join Date: Sep 2006
Posts: 10
It does. Its not like the typical bad muffler sound but yes it sound kind of loud. Not sure how to describe it.
Reply With Quote
  #5  
Old 09-22-2008, 11:50 AM
JimF's Avatar
'94 S500: only 793 sold!
 
Join Date: Mar 2001
Location: San Diego, CA
Posts: 1,933
When the cats/exhaust mufflers plug, you loose the "bass" so it sounds like it's screaming . . . take it to a muffler shop to get it confirmed.
__________________
Regards . . . . JimF
-------------------
'94 S500 Cpe

Visit my Mercedes Web Page
Reply With Quote
  #6  
Old 09-22-2008, 11:58 AM
Registered User
 
Join Date: Sep 2006
Posts: 10
The thing is that I just bought it. And it was acting up when I test drove it but not this bad. Then I drove it home for one and a half hour and than things got worse. But I don't exactly know how this car was supposed to sound. Either way I will take it a shop and do a back pressure test on it.

Even though the people before didn't take good care of the car, with 115k miles I still have a lot of fair in this engine. But I was aware that I was gambling my money when I bought it. $4k for the car.

Will keep updated.
Reply With Quote
  #7  
Old 09-22-2008, 09:26 PM
Registered User
 
Join Date: Sep 2006
Posts: 10
Exclamation

Here I am replying back. Just got one of the catalyst converters replaced. One of them was completely clogged creating a back pressure of 30 psi. Max should be around 2 psi. So I took the car out of the shop got up to 50 miles about 400 yards from the shop that car turned off while driving. So I pulled over to the side and it is acting like it is a dead battery. The starter will turn the engine but only for two seconds. Tried to jump it swamped the batter from another MB but no luck. It acts like it is a dead battery but I know that is not the problem. And the car have been starting right up every time. And I tried to jump it right after it turned off. Very frustarating


When it turned off since the car was still rolling I put it neutral and tried to start the car. I wonder if I ruined the starter!

I dropped it at a mechanic. I am worried it has not messed up the engine. Well, what can I do.

BTW, the muffler guy had never seen a catalytic converter cloged that bad.

But thank you all for your advice.
I feel very disappointed and sad now.
Reply With Quote
  #8  
Old 09-22-2008, 11:16 PM
JimF's Avatar
'94 S500: only 793 sold!
 
Join Date: Mar 2001
Location: San Diego, CA
Posts: 1,933
Glad you got the cat fixed. Now you know what a plug exhaust sounds like.

Wouldn't think it's a battery . . more like an ECU failure. . . time to get the codes read.
__________________
Regards . . . . JimF
-------------------
'94 S500 Cpe

Visit my Mercedes Web Page
Reply With Quote
  #9  
Old 09-23-2008, 01:45 PM
Registered User
 
Join Date: Apr 2005
Posts: 20
I hope for your pocketbooks sake this doesn't turn into one of those

'the cheapest MB's are the most expensive MB's'
Reply With Quote
  #10  
Old 09-23-2008, 02:53 PM
Registered User
 
Join Date: Sep 2006
Posts: 10
So I just talked to the shop today where I dropped my car. They have been able to get it started. Now it starts fine again. I can't really explain why the car would not start yesterday even with a battery swap and trying to jump it. But if it doesn't do it anymore who care. But time will tell.

But the next problem that seems to remain is the fact that car will ide fine but if you rev up the engine and then take off the gas pedal or brake the car rpm go down and will not stay at low rpm/idle but it dies right away. Any idea on this issue? Thank you again.
Reply With Quote
  #11  
Old 09-23-2008, 07:20 PM
JimF's Avatar
'94 S500: only 793 sold!
 
Join Date: Mar 2001
Location: San Diego, CA
Posts: 1,933
. . . codes . . . . get the codes read . . . .
__________________
Regards . . . . JimF
-------------------
'94 S500 Cpe

Visit my Mercedes Web Page
Reply With Quote
  #12  
Old 09-24-2008, 01:47 AM
Registered User
 
Join Date: Sep 2006
Posts: 10
I am back with news.

I just finished a HOT ENGINE compression test for a second time. After replacing the oil filter, oil, plugs, and the clogged cat converter, unlike before this time I got compression of 150-155 psi an all the cylinders. Should this be more acceptable? What are you guys getting?


Second, bad news, is that now the car revs up to red line but there is a major problem with power loss. Car idles fine and wont overheat in idle but if I setup on it and rev up the engine in about 10 min of driving it will overheat. Also tried to go up the hill car had hardly any power and died half way through. Its not the tranny I know, but the car has no power to pull and as the hill got steeper the cars rpm's got lower until death.

Now could this be still that my compression is yet too low! Or could it be some fuel issue? I know the car had been sitting for a while.....

Also, I get Check engine light, Cylinder 8 missfire, took out all the plugs, plug 8 still looks brand new and white..I might have a plugged injector there, don't you think?
Attached Thumbnails
98 SL500 Overheat No Power Only 3000rpm-sany0251.jpg  
Reply With Quote
  #13  
Old 09-24-2008, 05:37 PM
Registered User
 
Join Date: Mar 2007
Location: Florida
Posts: 130
Quote:
Originally Posted by JimF View Post
. . . codes . . . . get the codes read . . . .
You tried Jim.

Reply With Quote
Reply

Bookmarks

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On
Trackbacks are On
Pingbacks are On
Refbacks are On




All times are GMT -4. The time now is 04:40 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2018 Pelican Parts, LLC - Posts may be archived for display on the Peach Parts or Pelican Parts Website -    DMCA Registered Agent Contact Page