Sway Bar - E420 - is there an "up side"
I removed the sway bar off the W124 - E420.
Planning to repaint the bar - I didn't mark "top". Now I see that the ends have a slight "tilt up" or down. (Bend of about half inch) :confused: Is the tilt part of the design, of a bend after 185,000 miles? Do Sway Bards "go bad" My project was just to repaint and re[plash the bushings. Thanks |
The ones on the wifes' 400E appear to drop a bit at the ends,,, which would make sense I guess. I doubt if a sway bar would bend over time,,, but I've been wrong before.
|
There is a tilt
Posting for the post project update
There is a tilt to the sway bar "Murphy" told me how to install the bar. and sure enough it was wrong - bar did not line up with "bolt downs" by the wheels. Flipped to the correct orientation - and voila - the parts fit together. Now to the next project - I'm finding a car with 188,000 miles needs wear-out partts need replacing. found the front bearings need replaced :( |
All times are GMT -4. The time now is 02:24 AM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2024 Pelican Parts, LLC - Posts may be archived for display on the Peach Parts or Pelican Parts Website