|
|
|
#1
|
|||
|
|||
'92 140 ASR box replacment
Hello all,
I had my 92 500SEL checked out for a ASR/ABS light on, he found a code for the rt front wheel sensor missing. He then checked the sensor and said it was working fine. He said the signal was present at the controlers pins so he thought the controler is bad. I got a used controler but when I installed it the light doesn't even turn off like the other controler did, just stays on. Is there anything that needs to be done to get the used controler to learn this different car? Just to explain the original problem, start car, lights go off. First time you hit the brake the abs kicks in and the lights come on. no traction control or abs when light is on. If I start car and take off in the snow, traction works until I hit the brakes. Thanks Ron |
#2
|
|||
|
|||
the symptoms you describe usually mean that you need to replace both front abs sensors.you can try taking them both out of the wheel hubs and cleaning.if you f ind a lot of metal stuck to the ends that could cause the problem.
__________________
David S Poole European Performance Dallas, TX 4696880422 "Fortune favors the prepared mind" 1987 Mercedes Benz 420SEL 1988 Mercedes Benz 300TE (With new evaporator) 2000 Mercedes Benz C280 http://www.w108.org/gallery/albums/A...1159.thumb.jpg |
#3
|
|||
|
|||
Sounds to me like a brake switch, inexpensive part and easy to replace
|
#4
|
||||
|
||||
I agree.
__________________
Master Computer Engineer, A+, Network+, MCP/MCSA/MCSE 4/2k/2k3 - Messaging, MCTS, MCITP, MCT, Brainbench, ICDL and starting Ph.D 380SE 1984 <------- Totaled by flipping accident 300SE 1988 <------- Sold Volvo S70 2000 <---- 4 family Opel Omega 2002 <-- 4 family 560SEC 1989 <------ Sold 560SEL 1990 <------ Sold 560SEL 1991 <------ 4 my mother 560SEL 1989 <------ Sold 600SEL 1992 <------ Current http://search.ebay.com/_W0QQsassZkhazenzcc |
#5
|
|||
|
|||
Any thoughts on the used controler that I bought? Should it act just the same as the one in the car or is there something that needs to be done to it to get it to work.
I need to know because if there is something wrong with it I can return it, if it is ok and just needs to be programed or something it wouldn't seem right to return it because I needed a test part. The left front sensor was replaced not that long ago because the speedo needle was jumping, that took care of that problem. And since he tested the rt front and said the signal was good why would the controler spit out a bad rt front sensor if it's the brake light switch? |
Bookmarks |
|
|