|
|
|
|
|
#1
10-21-2001, 09:02 PM
|
|||
|
|||
|
Crankshaft Pulley Bolt Removal
Have a 27 mm crankshaft pulley bolt that is resisting removal. Initially used a 1/2" air impact wrench with a max torque of 420 lb-ft; switched to a 3/4" impact, with a max torque of 700. Using a 6" extension bar with both to gain access to the bolt.
Unable to budge the bolt at this point. Any suggestions? Move up to a 1" drive? TIA. 
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Is it possible to retap the 27MM crankshaft pulley hole where bolt fastens? | airfoill | Diesel Discussion | 37 | 07-22-2011 06:05 PM |
| Request to members in Germany - Klann or SIR spring compressor | Thomaspin | Tech Help | 59 | 09-02-2006 01:25 PM |
| Crankshaft pulley bolt size? (M103) | pmizell | Tech Help | 2 | 03-06-2002 11:15 PM |
| 300E belt tensioner problems | anthonyb | Tech Help | 16 | 10-08-2001 09:15 PM |
| Broken crankshaft pulley 240D 83 | Carrameow | Tech Help | 9 | 02-25-2000 02:37 AM |
Threaded Mode
