|
|
|
|
|
#1
05-22-2009, 04:31 PM
|
|||
|
|||
|
1989 300te...re-torque head...help!
I noticed some gunk on the cap of my anti-freeze resivoir. My mechanic says that after 6 years since he changed the head gasket, it couldn't hurt to re-torque. He has been busy, so he gave me his torque wrench and wants it back over the weekend. Problem is...don't know the torque ft/lb. or the sequence. HELP! 1989 300te
|
|
#2
05-22-2009, 07:27 PM
|
|||
|
|||
|
inline six? front of engine 12 8 4 2 6 10 14 Rear of engine
..................................11 7 3 1 5 9 13 Torque 1st stage 55 NM 2nd stage 90 degree tightening angle 3rd stage 90 degree tightening angle How's that work for ya?
|
|
#3
05-22-2009, 08:25 PM
|
|||
|
|||
|
The headgasket is a no need of retorquing...
You can simply tighten it a bit. You would have to remove each bolt, measure stretch to make sure they are usable-then retorq it. I'd say you need a headgasket. Make sure the head is flat and no damage when it goes in...
|
 |
| Bookmarks |
|
|
Linear Mode
