|
Different part #'s for 92 400E rotors??
I was shopping for braks rotors for my 1992 400E and I got two different part #'s for them??? Also anyone have any experience with Centric rotor?
|
I believe there were both a single mass and a dual mass rotor offered, just use the 1994 E420 part number for the dual mass (better) rotors.
|
At one point during the production of the 400E, there was a front brake caliper and rotor part change at the factory. Your best bet would be to source via chassis serial number.
|
^ 93 was the production year changeover. A 92 caliper will NOT fit a 93 rotor. A 93 caliper will fit a 92 rotor, but you run risks when the pads get low...
So for the OP -- You need to get a 92 rotor (295mm x 22mm) |
you 100% positive about that?
I have a 1992 caliper on a 1994 rotor and even though it was designed for a thinner rotor, it fits fine with OE pads and the balance is spot-on |
| All times are GMT -4. The time now is 11:54 PM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2025, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2024 Pelican Parts, LLC - Posts may be archived for display on the Peach Parts or Pelican Parts Website