|
|
|
|
|
#1
12-28-2001, 07:06 PM
|
|||
|
|||
|
No heat
My 420SEL is not putting out any heat, no matter which setting the fan is on. I turned the temp control to max heat and nothing. Cool air only blows (outside temp is below freezing). Engine temp is normal. 80 degrees is reached in normal time and stays at 80 while driving, so I don't think it is the thermostat. Obvious first conclusion is the climate control buttons, any other ideas?
PS. Benzmac if you are there I replaced the OVP relay and my rough idle and stalling problems are cured. Thanks for the advice.
__________________
Jason Priest 1999 E430 1995 E420 - retired 1986 420SEL - retired 
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Interesting Post on AC from the Ritter/Easley Board | ctaylor738 | Tech Help | 4 | 08-08-2003 06:36 PM |
| Plenty of heat...little heat....slow down...heat comes back | Dirty Ern | Diesel Discussion | 15 | 04-02-2003 11:48 AM |
| injector heat shields for a 300D - are they necessary? | Kent300D | Diesel Discussion | 13 | 09-19-2002 11:18 PM |
| New AC Servo and Amp, Still Full Heat | Elripster | Tech Help | 2 | 11-27-2001 09:35 PM |
| New AC servo and amp, still full heat | Elripster | Diesel Discussion | 0 | 11-26-2001 08:38 PM |
Threaded Mode
