|
|
|
|
|
#1
01-08-2002, 02:11 AM
|
|||
|
|||
|
New Head Bolts ? 126 chassis V-8 ? HELP?
I am about to torque my right head after a rebuild (and new head gasket/cam/followers/valve seals/) on my '85 380 SE.all the bolts are in ,but not tight.I was about to torque them,but am now confused about weather I need new head bolts or not because of "Stretching"?Everything came apart no problem,all bolts looked great I cleaned all threads and used motor oil on the threads before I installed them.Do I really need new bolts?Is the problem when I torque them ( thread damage?).Any input greatly appreciated.
__________________
'60 190b '77 300D '78 240D '82 300TD 
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| M103 Cylinder Head Bolt did not torque up like others. Stripped? | scanny | Tech Help | 11 | 06-02-2007 02:55 PM |
| 380SEL replace 6 bent valves or used head? | New2MBZ | Tech Help | 0 | 07-30-2003 02:17 PM |
| Head bolts ...help | Philnguyen | Tech Help | 1 | 03-19-2003 11:12 PM |
| Tool to remove head bolts on M103 | Maddog | Tech Help | 3 | 05-26-2002 03:11 PM |
| a couple of questions on head removal | MarkM | Diesel Discussion | 14 | 02-13-2002 12:43 PM |
Threaded Mode
