Parts Catalog Accessories Catalog How To Articles Tech Forums
Call Pelican Parts at 888-280-7799
Shopping Cart Cart | Project List | Order Status | Help



Go Back   PeachParts Mercedes-Benz Forum > Mercedes-Benz Tech Information and Support > Tech Help

Reply
 
LinkBack Thread Tools Display Modes
  #1  
Old 07-06-2011, 07:29 PM
LaughingGravy's Avatar
Mmm.... Diesel.
 
Join Date: Oct 2003
Location: N. NJ
Posts: 434
Leaky '83 300TD shocks Help, Please.

Please take a look at the pictures in my album
Near as I can tell, I have the dreaded leaky rear shocks.
I still have fluid in the front reservoir, at the higher end of not quite full.
When I start the car, there is a steady drip of fluid coming out of where you see the obvious leak.
The accumulators are bone dry in appearance.

With a load in the rear of about 260 lbs (sound equipment, not me ), it still rises after sagging over night.

The ride has been bouncy, but this obvious leak just happened.
The right is worse than the left, but not by much.

Any advice? Where does the leak usually happen with these? Is it at the top and it is trickling down to the bolts that you see in the pics?

Is this the likely cause of my woes, replacement of these?

Does anyone have any used ones they know are good, or (ha ha) new that they are not using and are willing to part with at a reasonable price for a really nice family guy who wants to take the 300TD family truckster camping because that's what we can afford?

Any help, as always is greatly appreciated.


Thanks.

__________________
85' 300D No inspection, No registration fees, Cheap insurance
"If my calculations are correct, when this baby hits 88 miles per hour, you're going to see some serious %$&^."
Reply With Quote
  #2  
Old 07-06-2011, 11:45 PM
Registered User
 
Join Date: Nov 2010
Location: Southern maryland
Posts: 29
drip

the accumulators, are what would give you the bouncy ride.if the struts still work,and you do not have to add fluid often,unless you want to spend a big hunk of change,use it the way it is.good luck
Reply With Quote
  #3  
Old 07-07-2011, 07:34 AM
LaughingGravy's Avatar
Mmm.... Diesel.
 
Join Date: Oct 2003
Location: N. NJ
Posts: 434
This appears to be a pretty big leak or set of leaks, though.
With the car running for a minute, it leaves a puddle of about a full ounce on the one side, and when I pull in or out of the driveway, it's a steady trail, not a trail of drips.
Earlier, I wrote that it is more on the right side than the left.
That was before I jacked it up and had it on jack stands.
Once I let it down, the left side is now worse, and the right side seems to have reduced itself to a minor drip in comparison to the left one, which is now creating the ounce after a minute.
With such big leaks, does it make sense that the bounce is still the accumulators?

Isn't the whole thing one big circuit of fluid?

The leaks are big enough that I don't want to risk any long drive for fear of running the pump dry and then having to replace that.
__________________
85' 300D No inspection, No registration fees, Cheap insurance
"If my calculations are correct, when this baby hits 88 miles per hour, you're going to see some serious %$&^."
Reply With Quote
  #4  
Old 07-07-2011, 05:58 PM
Registered User
 
Join Date: Nov 2010
Location: Southern maryland
Posts: 29
Cool bounce

the accumulator sphears have gas in the top half this is isolated by I think some sort of membrane, such as is in citroens. the gas being compressed by verticle motion of the wheel compresses the gas, when the gas goes away in time there is nothing to dampen the movement,thus a choppy ride.the sphers are not expensive and easy to change,I have done it on my wagon.but with the leaks you have, your going to have to repair the struts.did you check for any hose leaks.do you know what fluid is in them, a wrong fluid could cause them to fail.I used shell aero 9, excuse my terrible spelling. one thing to do,is wash those things well with some soap and water, then throw talcuum power all over the area. start the car bounce it up and down some, get a flashlite, and try to pin point the leaks. good luck.miker

Last edited by rybikowsk; 07-07-2011 at 06:00 PM. Reason: spelling
Reply With Quote
  #5  
Old 07-07-2011, 08:19 PM
LaughingGravy's Avatar
Mmm.... Diesel.
 
Join Date: Oct 2003
Location: N. NJ
Posts: 434
I got to the top of them after taking apart the internals of the back of the car. No leaks at all at the top that I can see through the holes. It really appears they are leaking at the bottom.
I can take care of the accumulators later to deal with any bouncy ride afterward if I need to, but these leaks are bad enough that I really have to take care of the main actuators first.

I've looked at all the writeups that I can find, but I can't seem to find any writeup or pictures on the actual replacement of the actuators/struts.

Is this something I can do with the car up on the jack stand one wheel at a time?
How easy is it to compress the strut into place?

I replaced the front struts fairly easily.

__________________
85' 300D No inspection, No registration fees, Cheap insurance
"If my calculations are correct, when this baby hits 88 miles per hour, you're going to see some serious %$&^."
Reply With Quote
Reply

Bookmarks

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On
Trackbacks are On
Pingbacks are On
Refbacks are On




All times are GMT -4. The time now is 01:27 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2024 Pelican Parts, LLC - Posts may be archived for display on the Peach Parts or Pelican Parts Website -    DMCA Registered Agent Contact Page