![]() |
|
|
|
#1
|
|||
|
|||
Need Help/Advise Removing RennTech Exhaust
Hello Guys........... I came across a 1992 400 E with RennTech exhaust at my local Pic A Part yard. I would like to remove at least the muffler/tailpipe to install onto my 1994 E420....... Can Anyone offer advise on approximately where to cut the pipe AND what type of hand saw will i need to cut pipe?? I do have clear access to the hangers/mounts but i dont know what to use for cut Or where to make my "chop" Any Advice/Help/Suggestions is Greatly Appreciated.... Thanks ; In advance,,,,,,,,,,,,,,,,,,Chance
|
#2
|
||||
|
||||
Go to the pawn shop and get a battery powered sawzall, cut as far forward as you can safely, probably where it starts to go under the passenger seat. That sawzall will turn the job into seconds. You'll need one for any serious automotive work anyhow.
Watch out for fuel lines.
__________________
03 540I (GAK!!) 81 280E (W123) 70 LeMans Sport with pissed off Poncho 462" 1989 Silverado Step Side (under the knife- complete restomod) |
#3
|
||||
|
||||
Battery power does not last,get a corded sawsall its what I use.I like to cut after a hangar,so new pipe will be supported.
__________________
1999 w140, quit voting to old, and to old to fight, a god damned veteran, deutschland deutschland uber alles uber alles in der welt |
![]() |
Bookmarks |
|
|