|
|
|
|
|
#1
09-19-2011, 03:04 PM
|
|||
|
|||
|
92 300 TE 4matic power seat control microswitch question
My pass side seat back would go back but not forward.
I removed the control switch on the door. I found that the microswitch for the seat back is only works one way. I moved the wires inside the clamp so I am using the headrest switch to move the seatback now but the headrest only goes down. My question is: Do the microswitches come off the circuit board inside the control? If they do I can try to source a new one at a wreckers, or at least swap the seatback and headrest microswitches. Thnaks Jim
__________________
92 300 TE 4matic 
|
|
#2
09-20-2011, 08:21 AM
|
|||
|
|||
|
A good used seat switch would be the simple choice.
__________________
MERCEDES Benz Master Guild Technician (6 TIMES) ASE Master Technician Mercedes Benz Star Technician (2 times) 44 years foreign automotive repair 27 Years M.B. Shop foreman (dealer) MB technical information Specialist (15 years) 190E 2.3 16V ITS SCCA race car (sold) 1986 190E 2.3 16V 2.5 (sold) Retired Moderator
|
|
#3
09-20-2011, 11:11 AM
|
|||
|
|||
|
Door Switch - Dry joints
It has been a while since I fixed my drivers door switch. I did lots of continuity checks to narroe down where to look on the switch and then looked at the solder joints with a magnifing glass only to find "odd" hazy looking solder joints that were indeed the problem. A dab with the soldering iron and the switch was repaired.
|
 |
| Bookmarks |
|
|
Linear Mode
