|
|
|
|
|
#1
01-06-2012, 11:18 AM
|
|||
|
|||
98' C280 (2.8L V6) Thermostat housing bolt torque specs
Hello EVERYONE!,
Doing the thermostat on my 98' C280 tomorrow because it's going to be a balmy 60 degrees F here in NoVA tomorrow, going to pick up the part now and I just need the torque values for the two bolts that hold the housing to the motor. If anyone's done this before on the V6 any tips or cheat would also be greatly appreciated. NP
__________________
"If it's not BLOWN, it sucks" 1998 C280 Sport - Member 744 Crew 1988 Toyota MR2-Kompressor(No. 3) 168K+ Miles Prior MB Cars 1974 450SLC & 1985 190E 2.3 Click This Link - IOS, Greece - Get Your Phreak On 
|
|
#2
01-06-2012, 07:08 PM
|
|||
|
|||
|
As a general rule, I never torque steel bolts into aluminum more than 10-15 nm.
__________________
2009 E320 Bluetec 117,000 1995 E300D 306,000 Sold 1996 Ford Taurus LX 130,000 Sold 1985 300TD Still 225,000 Sold 2016 Ford Fusion 24,900
|
|
#3
01-07-2012, 10:21 AM
|
|||
|
|||
|
Thanks, I'll torque it to 13nm then.
NP
__________________
"If it's not BLOWN, it sucks" 1998 C280 Sport - Member 744 Crew 1988 Toyota MR2-Kompressor(No. 3) 168K+ Miles Prior MB Cars 1974 450SLC & 1985 190E 2.3 Click This Link - IOS, Greece - Get Your Phreak On
|
 |
| Bookmarks |
|
|
Linear Mode
