|
|
|
|
|
#1
02-19-2002, 05:16 PM
|
|||
|
|||
|
O2 question
Fastlane Phil suggested I check with you guys on this. I replaced the O2 sensor on my '93 500E. The check engine light is still on. I would guess that I need to reset the fault code. Can you guys help me with that procedure? Thanks,
Jay 
|
|
#2
02-19-2002, 06:10 PM
|
|||
|
|||
|
The easiest way is to disconnect the battery for a moment.
If you want to do it properly, read the article I wrote on evaluating engine controls in the DIY section or at this link: http://www.continentalimports.com/ser_ic20134.html
__________________
Steve Brotherton Continental Imports Gainesville FL Bosch Master, ASE Master, L1 33 years MB technician
|
|
#3
02-20-2002, 12:03 AM
|
|||
|
|||
|
Thanks Steve!
Jay
|
 |
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 83 300CD tranny modulator question | freesprung | Tech Help | 0 | 04-07-2004 10:10 PM |
| Trouble Codes Question | talons40 | Tech Help | 2 | 08-22-2003 02:36 PM |
| Center Console Question | hippie_elmo | Vintage Mercedes Forum | 2 | 02-01-2002 11:47 PM |
| 190E tire question | cossie | Mercedes-Benz Wheels & Tires | 14 | 01-31-2002 05:49 PM |
Linear Mode
