|
|
|
|
|
#1
03-28-2013, 10:51 PM
|
|||
|
|||
|
Engine Fault Code
95 E320 Coupe (67,000 actual miles) California Car
The engine light came on - it has a 16 pin harness with a push button. I can't find how to hook up my OBDII sensor to it. I think I just push the button to find the trouble, but not sure? Anyone have directions? 
|
|
#2
03-29-2013, 12:23 AM
|
|||
|
|||
|
Turn key on engine off ,hold buttton for 3 seconds , and count flashes 5 flashes code 5, 26 flashes code 26 , report what youve got
|
|
#3
03-29-2013, 12:53 AM
|
|||
|
|||
|
The Diagnostic Module (DM) may only give you a partial picture of the problem. You will need to look at pin 8 and pin 14 as well by making your own diagnostic device. Search for this thread below...
E320 16 PIN DTC Charts Then post your results....For starters, report the DM flash codes first....
__________________
--------------------- 200 75 W115 (Mom's) 190e 90 2.6 W201 E320 95 Wagon W124 72 BMW 3.0 CSI
|
|
#4
03-29-2013, 03:05 AM
|
||||
|
||||
|
That is because it is not ODBII exactly. You must use the DTC to get the codes.
__________________
2016 Monsoon Gray Audi Allroad - 21k 2008 Black Mercedes E350 4Matic Sport - 131k 2014 Jeep Wranger Unlimited Sahara - 62k 2003 Gray Mercedes ML350 - 122k
|
 |
| Bookmarks |
|
|
Linear Mode
