|
|
|
#1
|
|||
|
|||
Correct Orientation of exhaust manifold gaskets
Motor is a 110.
Geting ready to pull a manifold, and the gaskets I received appear to be stainless steel. When laid on the flatter side and then viewd from the side, there is a ridge in the middle throughout the full circumfrance of the gasket. Which direction do I orient the ridge? To the manifild, or to the head? Or is it a mute point and the orientation only works one way and will be obvious when I've pulled the manifold?
__________________
S, J.R. Brown 2000 G500 LWB Obsedian Black 2005 Toyota Tacoma Access Cab Off Road Sport 1993 Volvo 240 Sedan Anthracite 1980 450SEL Champange (owned it for 15 years. Great car) 1986 280GE LWB Anthracite (Sold it and kinda wish I hadn't) |
#2
|
||||
|
||||
JR,
If they are similar to the gaskets on the 560, the metal side goes toward the head and the fiber side toward the manifold. What you have to watch closely is how they are situated, they can be put on 180* out. On the 560, three are one end up and the fourth is flipped 180* - if that makes sense. I'm guessing your's will be similar. I had an exhaust leak, figured out which gasket, and replaced the whole side. It took sitting with the manifold in my lap and fitting each gasket to determine the orientation. Then I laid them out on the fender in order so I could get them on correctly.
__________________
Mike Tangas '73 280SEL 4.5 (9/72)- RIP Only 8,173 units built from 5/71 thru 11/72 '02 CLK320 Cabriolet - wifey's mid-life crisis 2012 VW Jetta Sportwagon TDI...at least its a diesel Non illegitemae carborundum. |
Bookmarks |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Need a 240D exhaust manifold | bennett | Diesel Discussion | 4 | 04-09-2003 08:07 PM |
6.3 Exhaust Manifold Bolts | TexasStarMan1 | Tech Help | 2 | 11-02-2002 04:29 PM |
What are the correct o rings for the R4 at the lower manifold and compressor. | sainttammany | Tech Help | 2 | 08-31-2002 01:05 PM |
Exhaust Manifold Leak | Bazzman | Tech Help | 2 | 03-17-2002 07:54 AM |
190 Exhaust Manifold | mwfameli | Tech Help | 1 | 05-06-2000 03:41 PM |