Extra Nipple on Bottom Of New Waterpump? -190E

I currently have been replacing the cooling system on my '85 190E 2.3-8v -ie. hoses, waterpump, radiator. To my understanding the 'new' pump for this car is a little different, and everywhere I look it says to replace the lower radiator hose also.

The thing I can't seem to figure is the lower radiator hose that I purchased PN: 201-501-42-82 does not seem to be any different than my current one. But they did give me another hose which I can't seem to figure out where it's supposed to go PN900271-008043. This hose is about 5/8" OD and about 3 ft long.

I did notice however an extra nipple on the bottom of the new waterpump, which I think this hose might supposed to be attached to. However, I don't know where the other end is supposed to attach if this is the case.

If this is not the case, could someone please direct me as to where this 'new' hose is supposed to go. And also, please let me know what that nipple on the bottom of the new waterpump is for?

[mbdoc]

That nipple is for a plastic "drain" hose that MB had installed so that when the waterpunp starts leaking it wont get on the belt & pulleys as soon.

So, on install nothing would be connected to this. Only when the pump is faulty would it be drained through here?

Thanx a bunch. Now all I have to do is drop in my new radiator and connect hoses -didn't want to continue becase of this.