|
|
|
#1
|
||||
|
||||
How to collapse new chain tensioner for install? M117
I cannot get this piston to go in far enough to install it. Brand new MB tensioner. I read somewhere it contains a ratcheting mechanism? How do I put it in?
__________________
Ich liebe meine Autos! 1991 Mercedes-Benz 560SEL | Megasquirt MS3-Pro | 722.6 transmission w/ AMG paddles | Feind Motorsports Sway Bar | Stinger VIP Radar | AntiLaser Priority | PLX Wideband O2 | 150A Alternator | Cat Delete 1981 Mercedes-Benz 300SD | Blown engine, rebuilding someday... 1981 Mercedes-Benz 300SD | Rear ended, retired in garage. 2009 Yamaha AR230HO | Das Boot Excessive speeding? It ain't excessive till I redline! |
#2
|
|||
|
|||
I have long 8mm bolts with nuts on them. install the tens. with the long bolts, thread the nuts against the tensioner until it's tight on the block. remove 1 long bolt, install the correct bolt. repeat. haven't done 1 in 10 years or so, the dozen or so chains I did, never failed. always oe tens., also. good luck, chuck.
|
Bookmarks |
|
|