![]() |
Remote start tach signal...
I am currently installing a remote start unit to my MB 230CE w124 1988, and need a "traditional" tach signal.
The tachometer signal in my car delivers +12V decreasing as RPM increases. The remote start unit needs a voltage increasing by increasing RPM (like when you have a triggering signal for each revolution). Is there any sensor on my car which I can hook up to to get such a signal? I have heard about a diagnostic output, but not sure if this is correct. If so, could someone tell me the pin-numer for the RPM output? Thanks in advance! Anders Eklo - Norway. |
On the front of the engine there is a signal. You will have to locate the sensor and follow the wire to the diagnostic connector.
|
All times are GMT -4. The time now is 05:48 PM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2025, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2024 Pelican Parts, LLC - Posts may be archived for display on the Peach Parts or Pelican Parts Website