|
|
|
#1
|
|||
|
|||
Dash Warning Light "Flicker"
I have a 1992 600 SEL, and once in a while, while using either the turn signals or the wipers, the dash warning lights will all come on for just a brief "flicker", and then go out again.
They come on normally and then turn off upon start-up, and don't do this unless that one stalk is used, and it doesn't even happen EVERY time that stalk is used. Any ideas on what I'm looking at to fix this?? Pinched wire in steering column?? Bad cluster?? Thanks, Barry
__________________
Barry |
#2
|
||||
|
||||
Barry it could be as a result of a bad combo switch...try doing a search on the topic it seems like there was a post not long ago about this!!
good luck
__________________
Brandon 2008 S550 1957 Dodge D100 1967 VW Microbus 21 Window 2001 Suburban 2004 Beach cruiser bicycle -----------------GO DUKE!----------------- "It cannot be emphasized too strongly or too often that this great nation was founded not by religionists, but by Christians; not on religion, but on the Gospel of Jesus Christ. For that reason alone, people of other faiths have been afforded freedom of worship here." Patrick Henry 1776 |
#3
|
|||
|
|||
Thanks for the advice on where to start.
I would imagine that the switch itself could just be worn out, or maybe the contacts are just dirty. The car has 126k on it. I'll try some contact cleaner, and if no improvement, dig into the steering column. Thanks,
__________________
Barry |
Bookmarks |
|
|