Torrance, I have an extra 104 that I bought used just for the covers and such as I was going to build a c 36 motor from scratch, I eventually found
a good c 36 motor at a low cost, ill gather everything up tomorrow afternoon then ill pm you for address etc, back in the day we used to do headgaskets
on 104 engines 2-3 a week, just hand lap the valve install a new seal should be ok,exhaust valve or intake needed?

Shop said 2 bent intake valves on number 6.

might be related to the other thread you made where you mentioned the cams were off time.

New valves .. put everything together again. Started up nice and quiet but has a miss. Gotta track that down now.

Bad coil pack. Replaced and it runs beautifully with no leaks. Thank you everyone for helping me out


https://i.postimg.cc/xkGK1bsh/B993-A...7-D4-AD5-D.jpg