![]() |
|
|
|
#1
|
|||
|
|||
97 E320 in Limp mode
Trying to pass my father 1997 E320 to my son as his first car. The car sat for a long while with minimal use. The car has about 100K on it.
The issue is that the car is in limp mode and can not exceed ~35mph. The instrument cluster is functional with the exception of the the speedometer. Getting a warning light for ETS and ABS on the cluster. Pulling the codes I saw that the left rear ABS sensor was defective - that has been replaced. I disconnected the plug on the transmission and found lots of ATF. I cleaned the chassis side of the plug and replaced the plug housing. The car was suffering from limp mode still. ETS and ABS lights where still on I next replaced the sensor plate in the transmission - still in limp mode with the same lights on the cluster. Tested all fuses in the various fuse boxes found all where good Getting the following errors - that will not clear B1041 Fault in CAN Communication with control unit traction systems P1605 Rough road detection signal by comparing wheel speeds P0600 No or Incorrect CAN message from control unit ESP P1747 CAN Fault Where should I be looking next |
Bookmarks |
|
|