|
|
|
|
|
#1
06-15-1999, 11:08 PM
|
|||
|
|||
|
In my 87 300E, the light burned out that illuminates the vent control for the drivers' side. How do I go about replacing the light and where do I get a bulb to fit in there? Thanks in advance!
------------------ Chris '87 300E |
|
#2
06-16-1999, 12:57 AM
|
|||
|
|||
|
There is probably an official way to do this but this is how I dit it.
Look inside the four corners of the vent about .5" to .75". You should see a small metal tangs with a slot on the middle. The tangs need to be lifted and the vent worked out of the dash. Moderate to medium force should be sufficient. Once out the bulb replacement is obvious. I bought bulbs from the dealer for about 2 bucks each but I'm sure the local parts store has them too. John H |
|
#3
06-16-1999, 01:01 AM
|
|||
|
|||
|
Chris
Yes you can replace blub just unclip outer vent pull vent housing out replace blub. you can find the blub at any Mercedes dealer. (12v 1.2w)Blub hope this help! ------------------ MB STARS Master Guild Technician,12 years MB tech 5 years independent shop owner |
 |
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 300E - ABS light stays on intermittently | Phalcon51 | Tech Help | 14 | 11-04-2003 11:22 PM |
| underhood work light? 87' 300E | DanielW | Tech Help | 1 | 09-15-2002 03:50 PM |
| Check engine light -- 300E | pmizell | Tech Help | 11 | 09-27-2001 08:58 AM |
| 300E Oil Light - Hard Left Handers | dtanesq | Tech Help | 7 | 01-11-2001 05:47 PM |
| 300E interior light problem | Bobster | Tech Help | 1 | 12-07-2000 11:12 PM |
Linear Mode
