w210 window regulator instructions
My rear driver's side window has dropped down. Seems to me like the window regulator is bust. I took off the door panel (using the diy know how I acquired from you guys) but there is like a pink cover over it. Can anyone give me the instructions on how to fix it. I have a 97 e320. How much is the part, and what parts/tools do I need.
|
W210 Rear Windoe replacement
Once you have the Rear door panel off you have to peel off the Plastic liner to have access to the window regulator you must drill out the rivets that Secure the Window regulator to the door, Then remove the plastic clip at the Window regulator/door glass then slide the glass/window regulator off and remove the regulator ..Install is the reverse...and install new rivets(Note You Will Need a H.D. pop Rivet gun)And Its about a 30min job...Good Luck
Give the Fast Lane a Call For the Price..The Regulator With Rivets |
i have the same problem with my rear window
I m having a hard time removing the panel. was it difficult to get the door panel off on your car? from this board they mentioned that there should be three big screws to be removed. i have only found two big one and one small one. (one below the arm rest, one behine the black shaped plastic and the small one is from the U shaped plastic near the door latch) Where is the third big screw? thank you in advance for your help.
|
There is a screw behind the srs plastic plug,another under the arm rest,another behind the plastic cover for the inside door handle release,The lock pin,and pop it off( The Door Panel) with a plastic wedge...
|
There is no SRS emblem on the rear door panel
my car does not have the SRS emblem on the rear door panel..i see that emblem on the front door though. my car is a 96 E320.
|
Sounds like You have them all, Pop The Bottom edge of the door panel out/off and push the door panel up to release the arm rest/handle its secured to the door / Slides into the door...This should do it...
|
thanks Mark, i will try that tomorrow.
thank you very much..
|
Dont have a rivet gun, so I just took it to the mechanic to fix
|
rivet gun question
sorry for being naive but is there a special rivet gun or any would do? and H.D. means home depot right?
|
The Rivets Require a BIG Pop Rivet Gun!Heavy Duty..Not Home depot..You must have the Correct rivet gun!
The one that Comes as a Set Wont work...The Rivets are Big! |
rivet gun question
Mark, can this gun be purchase at any store you know? and it is very expensive? thank you.
|
Any (GOOD) Hardware store should have a Heavy Duty Pop Rivet gun..Have Not seen the gun at The Home Depot
|
W210 WINDOW REGULATOR
WHAT IF HE JUST REPLACES THE RIVETS WITH GOOD BOLTS AND NUTS ? [ I HONESTLY WANT TO KNOW THE EFFECT}
|
UPDATE
$350 to fix. Mech could only buy the regulator w/ motor. Does the E420 have the same probelms with regulators. I am considering dumping the 320 and buying a v8 w210 |
window fixed. Thank you Mark
Your instructions was right on. Once i got the door panel off, everything was just like you described. Thanks again for all your help. This forum is the best.
|
All times are GMT -4. The time now is 02:58 AM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2024 Pelican Parts, LLC - Posts may be archived for display on the Peach Parts or Pelican Parts Website