![]() |
|
|
|
#1
|
|||
|
|||
On my 83 240D I can lock/unlock my driver door from the outside with a key, but my inside door lock button is frozen in position.Pushing/pulling on it does nothing.
Again I went to a Junkyard today and took one apart, but this was after I had been thier already in the heat for two hours, so I couldnt concentrate. Unlike other cars, this thing seems to be one big assembly (Lock, outside latch and locking button, are one unit and its vacuum based.) I didnt have a vacuum pump. I couldn't figure out what did what even though I had a good look. The vaccuum lines run into the car body. How do I start Troubleshooting this? |
Bookmarks |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
83 240D How do I remove the inside door panels without damaging them? | Carrameow | Tech Help | 4 | 11-22-2002 10:06 AM |
Will Alum 240D Air Cleaner Fit on 300D | tcane | Diesel Discussion | 0 | 01-10-2002 07:33 PM |
83 240D Technical reason for trunk lock stuck shut? | Carrameow | Diesel Discussion | 8 | 02-12-2001 06:27 PM |
'77 240D Door Lock Leak | walt | Tech Help | 2 | 07-30-2000 10:04 PM |
Door lock diagnosis & repair, by popular demand | ncarter | Tech Help | 1 | 07-15-1999 10:24 AM |