I need to adjust the valves on my 1983 300SD Trubo Diesel. My friend and I removed the valves cover and measured the current calibration. What we found was that all the valves were adjusted at approximately .010mm. I did not recalibrated the valves because we could not determine which valves were the intake and which were the exhaust. If I stand in front of the engine (from the timming chain) can someone tell me wich is the intake valve and wich is the exhaust. I appreciate any advise. Thanks
------------------ |
If from the timing chain #1 exh #2 intake #3intake #4 exh #5 exh #6 intake #7 intake #8
exh #9 exh #10 intake. good luck. ------------------ MB STARS Master Guild Technician,12 years MB tech 5 years independent shop owner |
I was completely uninformed on this matter. Thanks for the input. I'll have a project for the weekend.
|
All times are GMT -4. The time now is 06:45 AM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2024 Pelican Parts, LLC - Posts may be archived for display on the Peach Parts or Pelican Parts Website