300E water pump replacement using snap on tool ?
Ok...Let me make sure I got this correct. I have just ordered the snap on tool part # FLXM13 for replacing the water pump the easiest way.
I start by removing the pulley then the serp. belt. Then use my new tool for getting the 3 bolts off and then remove the tensioner shock so that the 6mm allen bolt on the bottom is accesable. Then remove and roll out the water pump. Do I have this correct. Thanks. :) |
Also remove number 1 bolt for intake at front of engine for pump to easy roll out. holp this help
|
MB,
Thanks I almost forgot !! |
MB,
It has been noted not to add sealant of any kind to the O-ring but to apply a little grease to hold it in place while you install it. What kind of grease do I use? and should I place it around the entire seal or just in a few spots to hold it ? Thanks again, the reason I ask is my WP came with instructions (go figure) and they say to add sealant. While I honor the instruction of the posters here more than I do the manufacturers instructions I just want to make sure this thing doesn't leak after all that work. :) |
Just like you says put few spots of grease to hold the O ring in place will do it. any lube grease
|
All times are GMT -4. The time now is 07:24 PM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2024 Pelican Parts, LLC - Posts may be archived for display on the Peach Parts or Pelican Parts Website