|
|
|
|
|
#1
10-07-1999, 03:09 PM
|
|||
|
|||
|
Please go to www.jersey.net/~rtc/BENZ.html The picture shows my progress in rebuilding the 83 240D Engine. The Crankshaft is at TDC; the head is on. The "unclosed" chain has been threaded through the timing rails, sprockets and timing wheel.
I'll close the Chain after I install the Camshaft at TDC. Then I'll put the Chain Tensioner on. However how do I do this and preserve chain to cam TDC relationship? Wont there be a "shift" after installing the chain tensioner, throwing everything off? [This message has been edited by Carrameow (edited 10-07-1999).] |
|
#2
10-07-1999, 09:26 PM
|
|||
|
|||
|
I e-mailed you the process. Please use the board instead of my e-mail if you are going to post on both anyway.
Thanks ------------------ Benzmac: 1981 280GE SWB 1987 16V ASE CERTIFIED MASTER AUTO TECHNICIAN SERVICE MANAGER FOR 14 BAY FACILITY MERCEDES SPECIALIST 8 YRS PARTNER IN MERCEDESSHOP.COM |
 |
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Just how often should a timing chain be replaced? | Greg in Oz | Tech Help | 16 | 07-25-2005 05:02 PM |
| OM603 timing chain installation report | gsxr | Diesel Discussion | 3 | 08-15-2003 11:00 AM |
| 560 SEL Rocker Arm Removal | hbofinger | Tech Help | 10 | 07-23-2003 02:28 PM |
| slack chain TDC | william rogers | Tech Help | 3 | 09-04-2002 03:59 AM |
| Can I safety remove TDC pointer bolt and lower inner slide rail closing plug?? | 240Joe | Diesel Discussion | 3 | 11-25-2001 09:08 PM |
Linear Mode
