Tumbler won't turn
The tumbler of my 1987 300E will not turn. My son evidently inserted my BMW key into the ignition by mistake. I lubricated the tumblers but the key has difficulty going all the way in and once I get it fully inserted it will not turn.
Any sugestions? Smiles. |
do a seach about tumblers on the forum. eventually i hope u get it to turn. and when u do, get it out. my tumbler was stuck a month ago, and i got it turning the next day. but then the day after that it was stuck again, this time i had to park it in front of my GF's house for over half a month. finally just today i got a new tumbler in. cost for tumbler = $90, cost to cut it our $600. i'd like to think that i was very lucky i got it out again. it came out in 3 pieces.
oh for my advice if u can't get it to turn try ordering another fresh key. did the trick for me. good luck |
Here is a posting regarding ignition problems with a lot of suggestions: Ignition lock problem
Keep us posted, Haasman |
One or more pins are probably stuck.
You might try to shock the pins loose. I little judicious whacking on the inserted key or the cylinder housing might shake it loose. Take the panel off to get good access for a proper whacking. If you do get it loose, you may want to replace it before it jams again. It's much easier to remove while unlocked. |
All times are GMT -4. The time now is 11:28 PM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2024 Pelican Parts, LLC - Posts may be archived for display on the Peach Parts or Pelican Parts Website