Source for parts number book needed
 

Does any one know where I can get an illustrated book which shows the parts and their related factory numbers? This would be for W107 and W126 chassis cars.

I tried the eBay vendor - no luck.

Thanks.

I have never seen the dealer parts book for either of these on ebay or anywhere else. You might try www.tmcpubl.com, or send an email to cth@mbz.org.

Someone in the parts forum is offering a set of EPC CDs for less than $15.

Sixto
91 300SE
87 300SDL
83 300SD

Thomas
If you find a source. Let me know. I wouldl like one for the 107 and 123.
Dave

Part Numbers
 

hi guys

as luck would have it i just purchased that exact mb book with all replacement part numbers up thru 1991. it should be here in a week.

tks much
craig :D :D :D

The EPC covers all models up to the version date. It starts in the early sixties with 111,112, 110 chassis.

They are all boot-leg but are often available on ebay. One will need two CD drives or a "virtual CD" arrangemnent as both discs have to be available,

EPC
 

hi

i have that epc from ebay and i've yet to get it to fully work no matter what i do to the installation. i'm sure it's something that i'm doing. the only thing it does is go to the page that asks for the series # but i just can't get it to recognize 126 or w126

tks
craig

l bought the same crap on ebay....does'nt work either and l am sure its not something l am doing.

Re: EPC
 

I think it's looking for something like CB20 for 300SD or CA24 for 300SE; the 4th through 7th digits of your VIN. I don't know how you'd enter the series for early cars.

Sixto
91 300SE
87 300SDL
83 300SD

The EPC is designed to run on a proprietary Bell and Howell PC with both discs running. Getting it set up is a big problem.

The first screen up should be a picture of an SLK. In that screen the chassis number can be inserted or if you hit enter and chose "car" it will bring up a list of models which can be scrolled and clicked to enter. Very straight forward and both the sales designation (560SEL) and the identifying chassis number componenet (126.039) are listed.

bell and howell
 

hi steve

was there anything special about the b&h computer. or was it just the 2 cdrom setup. did it require anything in the bios/cmos to work?

thanks for the info i'll try it again.
craig

Just the two cd thing, I think. In installs that I have seen the thing was loaded as an update. I have heard that it often takes a number of attempts.

part numbers
 

hi all

i got the book in today. covers everything. even gives prt nos on audio speakers, paint you name it. don't have time rite now but i'll be back later today.
craig