![]() |
|
|
|
#16
|
|||
|
|||
Any last minute input on movovalve removal?
I've done the "search" on monovalve, mono valve, heater valve, 260E, 300E, and several combinations. I read the great DIY article by Steve Brotherton. (which is troubleshooting but not removal procedures). I've tried Google. I'm looking for a paragraph or pictures on how to remove the monovalve (1988 260E for me, or 1989 300e for Benz300). (Disconnecting the wire connector on top is obvious.) My only questions are: 1. Do I clamp off the hoses or will fluid loss be minimal? 2. How do I remove the pointy rubber connectors that seem to hold the entire unit in place? Do they slide, stretch, pull, twist (or just eventually break??? -my greatest fear!) Once I have guidance, or if I can figure it out alone, I'll take pix to post for others. Thanks a lot, Techie9 |
Bookmarks |
|
|