|
|
|
#1
|
|||
|
|||
This may be the most trivial repair in the history of this forum...The little silver button has fallen off the center of my left-hand four-gauge dial...is there an easy way to get access to this gauge and re-glue that little button back in place?
------------------ Tom '87 560 SL '74 MGB |
#2
|
|||
|
|||
I don't know that the 87' is exactly the same but it probably is. I have an 83' 500sl. The instrument cluster is only held in place with a rubber seal around it. You need to gently lift up on the dash above the instrument cluster and insert your fingers in between the dash and cluster, then gently tilt the cluster forward while pulling out. Don't pull to far as there was not a lot of slack in the cables and wires on mine. I did this while I already had the steering wheel removed. I don't know if you can get it out without removing the steering wheel. Now once its out, unfortunately I could not find any way to get the front panel off. However on the back you will find that the intruments are actually in three sections. There are several small hex head screws around the edge. Remove these. Also there will be a few of the same type screws where the guage sections overlap, these will need to be removed also. I believe the center section overlaps the to outside guages so you will probably have to remove them all to get to the left hand section. The job sounds alot bigger than it is. While I had mine out I cleaned everything and replaced all of the bulbs. It looks like the day it came from the factory.
Hope this helps. Gook Luck Marc |
#3
|
|||
|
|||
You do have to pull it out. There are special tools for this. Once out, you can take apart the clusters and glue the silver thing back on with super glue. (been there and done that)
------------------ Benzmac: Donnie Drummonds 1981 280GE SWB 1987 16V ASE CERTIFIED MASTER AUTO TECHNICIAN SERVICE MANAGER FOR 14 BAY FACILITY MERCEDES SPECIALIST 8 YRS PARTNER IN MERCEDESSHOP.COM |
#4
|
|||
|
|||
Donnie,
In the absence of special tools, sounds like the job can be done by hand, albeit awkwardly. Am I correct that there is perhaps "just enough" slack in the wires, etc., to give access to the backs of the clusters? And, it can be done with the steering wheel on the column? Thanks both of you...and to whomever shall follow. ------------------ Tom '87 560 SL '74 MGB |
Bookmarks |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Handy Gauges? Boost, oil pressure? | phidauex | Diesel Discussion | 7 | 10-28-2004 05:09 PM |
Access to Dashboard Gauges For Cleaning | Bill Driver | Tech Help | 0 | 09-30-2003 06:34 PM |
Access to '94 C-220 Instrument Cluster | Bill Driver | Tech Help | 1 | 09-25-2003 09:23 PM |
need black 500E dashboard | run.exe | Mercedes-Benz Performance Paddock | 4 | 05-27-2003 02:29 PM |
97 E320 Dashboard Cracked | royaiii | Tech Help | 6 | 08-30-2002 09:50 PM |