PeachParts Mercedes-Benz Forum

PeachParts Mercedes-Benz Forum (http://www.peachparts.com/shopforum/)
-   Tech Help (http://www.peachparts.com/shopforum/tech-help/)
-   -   Belt Tensioner Replacement (http://www.peachparts.com/shopforum/tech-help/76161-belt-tensioner-replacement.html)

Rp1906 09-30-2003 09:42 PM

1990 300E 2.6 Belt Tensioner Replacement
 
I am replacing my belt tensioner, tensioner shock, adjusting rod, and fan clutch bracket. I am down to the tensioner, but I am having trouble removing the water pump pulley. How can I prevent it from moving as I attempt to remove the 3 bolts that hold it in place.
I removed all but one of the bolts holding the bracket in front of the tensioner. The bolt on the far left of the bracket is loose but it will not come out of it's hole. Is this normal? My concern is, once I do remove the pulley, will the bracket holding the tensioner come off? Please advise.

Richard

fjones 10-01-2003 12:04 AM

I just did this on a 1900e-2.3.I used a rubber belt "wrench" I got at pep boys to hold the pulley.The bolts holding the bracket should come stright out ..Its abit of a job----not much room.Good luck.


All times are GMT -4. The time now is 05:32 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2018, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2018 Pelican Parts, LLC - Posts may be archived for display on the Peach Parts or Pelican Parts Website