|
|
|
#1
|
|||
|
|||
Where's Brake Stop Lamp Switch 92 500SL
Where is the brake stop lamp switch in a 1992 500SL? I have an ASR problem that seems to often be cured with replacing this switch. They have already tested/replaced the wheel sensors and the neutral safety switch.
Thanks in advance. |
#2
|
|||
|
|||
Look at the pedal, follow it up. The thing is on the braketry that holds the brake pedal.
Joe
__________________
Project Smoker, '87 603 powered wagon Hauler, 96 CTD can you say torque? Toy 73 Cougar xr7 convertible Acme Automotive Inc. Raleigh NC 919-881-0364 |
#3
|
|||
|
|||
Procedure
You'll have to turn this part clockwise (I believe) along the long axis of the car about 90 degrees, then remove it. I can't remember if there's a connector to remove, but suspect that tehre is. Fully extend the new part's plunger (it should make a clicking sound when you do this) and insert, then reconnect.
About 5 minutes to do. or 20 minutes if you wait until after dark and only have a penlight to guide you, like I did. Regards, Troy 1995 E420 |
#4
|
|||
|
|||
Thank you, thank you, yk2immel!! I followed your instruction and found the switch!! It's a biatch to remove for sure, but i turned clockwise and finally got it out. I've already got a new one and promptly reinserted it back to the housing.
The BAS light on problem went away completely after the install. Yeepee!! One quick question: I try to fully extend the plunger and then insert it, but the plunger seems to be depressed a bit when i plugged it into the housing. Is this normal? Thanks again guys!! |
#5
|
|||
|
|||
its cos its pressing against the brake pedal . depress the pedal when you install the switch. nice
|
Bookmarks |
|
|