job number for replacing distributor cap & rotor 300-E

[Bob G]

I have to say that me and Mercedes-Benz CD service manuals do not mix well.
I am either bline or need some education into the Mercedes-benz way of thinking .
I posted an earlier inquiry on replacing the distributor cap , rotor and o ring on my 1992 300-E M103 engine. I thank all you came to my post to help me out.

This morning I popped in the old CD into my computer to do a quick search to back up any information I needed. I logically looked in the first CD under maintance services even under spark plug replacement. I though the job number was 15 535 ? I could not fine it in both CDs . Were on earth did they list this service?

Bob Geco
1992 W124 300-E M103 engine

[softconsult]

Bob, I looked it up in my paper engine manual. It's job 15-535.

However, it basically says nothing that isn't obvious.
Remove the plastic shield.
Remove the three socket head screws that secure the Cap.
Remove the three screws on the rotor.

That's it.

I have done this on my M103. Simple, except for routing the wires and getting the plastic cover strip to stay in place.

Steve

[Greely]

On my 2 disk manual for my 90 300E m103. Follow the prompts below if your manual is the same:

Disk 1
Engine Manual
Combustion Manual
Electrical System engine
15-3010

Hope this helps

Ron