I got a 90' 300CE. It is a Californiya version. There is red light indicator in the computer outlet where techs stick their testers for diagnosticks. I have used this unit to reset the "Check engine" light several times, and I know that in the proces of reseting, this unit puts out a code by blinking with the red indicator. Is there any way i can get my hands on some sort of the table that will have this codes and their meaning. Going to the shop every time the light comes on is a pain in the ...
Its already been twice since the worning light came on and I reset it without knowing what it was about (it gave me codes 17 and 11). Thanks

Dmitry

[This message has been edited by DMITRY (edited 09-21-2000).]

D - this is the code for a '95 E320. Hope this helps.


1995 E320 3.2 L engine
(flashes on LED)

1 No malfunction in system monitored
2 Heated O2 sensor inoperative
3 Lambda control inoperative
4 Air injection inoperative
5 Exhaust gas recirculation inoperative
6 Idle speed control inoperative
7 Ignition system defective
8 Engine coolant temp. sensor, open/short circuit
9 Intake air temp. sensor, open/short circuit
10 Voltage at hot wire mass air flow sensor too high/low
11 TN-signal (rpm) at engine control module (N3/4) defective
12 Heated O2 sensor heater, open/short circuit
15 Wide open throttle information defective

This exactly what I need. Only its probably diferent for my car. Where didi you get this info from ?

Dmitry