|
|
|
|
|
#1
09-28-2000, 05:59 AM
|
|||
|
|||
|
on 1988 300E (W124). I am still trying to figure out best way to line up everything with regard to putting back on timing chain. How can you tell if someone previously put in a offset key? Is it when the camshaft lobes are between intake and exhaust about 20 degress?
[This message has been edited by Steve190E 2.3 (edited 09-28-2000).] 
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| OM603 - oil leak from exhaust port with new head! | gsxr | Diesel Discussion | 40 | 01-29-2019 10:52 AM |
| The #14 head on the 603, really bad? For sure? | bbeardb | Diesel Discussion | 70 | 04-30-2007 09:34 AM |
| 380SEL replace 6 bent valves or used head? | New2MBZ | Tech Help | 0 | 07-30-2003 01:17 PM |
| 380SEL head or used engine? | New2MBZ | Tech Help | 7 | 07-13-2003 11:12 AM |
| Finally!!!!!!! | MarkM | Diesel Discussion | 20 | 06-05-2002 12:12 PM |
Threaded Mode
