w107 rear brake caliper problem
 

I removed the right rear brake caliper to install a new one.
When I got back, I noticed...duh...the car had rolled off the jack stand. After getting the car back up, I noticed the flange which holds the nuts for mounting the caliper was damaged. Now I cannot bolt the caliper back on because the nuts do not line up w/ the rest of the assembly. I have to replace this flange. Does this mean I have to pull the axle/half shaft to get at the bolts holding the flange on? Does anyone know the part number for this flange? Better yet, any help would be appreciated!
:confused:

I'm not sure about the flange. But it does concern me about the "rolled off the jack stand" I'm concerned about your safety, setup and working on the car. A car should not Roll off the stands. You could have been hurt or killed. Buy some good jackstands and wheel chalks. We don't need to hear about your accident or untimely death.

Dave