Fuel Filter Replacement 2000 C-230 Compressor
1. Jack up Passanger side rear of car for clearance.
2. Unscrew 3 10mm nuts through access holes in black plastic cover. Use
3/8" driver with 12" extension. Remove plastic cover.
3. 3 rubber donuts hold fuel filter/ fuel pump clamp, remove them from bracket
using a screwdriver.
4. Unscrew phillips screw to loosen fuel filter from clamp.
5. Cut fuel hose clamps off fuel line using sharp knife.
6. Slide fuel filter out of clamp.
7. Install new hose clamps on fuel lines and connect lines to new filter.
8. Install new filter into silver clamp. Start Engine and check for leaks.
9. Shut Down engine and tighten philips screw into clamp.
10.Install donuts on brackets.
11.Install black plastic cover using 3 10mm black nuts.
12.Clean-up and lower car to ground. You saved $200.00!
|