ok, i know i'm resurrecting this post back from the dead...
anyway, i have the exact same problem and i'm about to tackle this harness problem, my question is...

where is the source of the wiring that powers the pump?
from what i've read the wiring goes (from the pump) to the foot area of the right rear passenger then where? does it go all the way to the right front passenger area? or does it cross over to the left front driver's side area?

reagarding distribution points, anybody know where they all are in a w124 sedan? the reason i'm asking is because my car originally didn't come with power windows and power seats... i now have the power seats installed with no way of adjusting them, short of hotwiring the seats, eventually i'll be installing the seat switches and i'd like to do it properly by running the wiring as it should be run. any help would be appreciated.

ps, i've seen the junction/distribution point at the driver side kickpanel, is this the only one? anybody know which sockets power which accessories?

thanks guys!

__________________

85 190E 2.3(SOLD)
86 230E (-->300D) sold
87 300D (-->300TD) sold
68 250S w/ a 615 and manual tranny (RIP)
87 300TD (SOLD)
95 S280 "The KRAKEN" (Turbo 2.9 602 transplant) traded
86 190E 2.3... current project