It doesn't look like anybody is interested in this thread, but i need to add one point now that i've done the drivers' side for those who might search for this DIY later.

Before, I alluded to the fact that the two "pegs" for the seat bottom switch are identical. i only said that because I happened to put them in the correct spot when I reassembled them last time. This time I didn't. When you look at them, you'll notice that the plastic housings that the metal dowl/shafts run through extend only on one side. Look at yours and you'll see what i'm talking about. In other words, these pieces aren't symetrical. The "extended" plastic hole needs to be pointed down. If you do this wrong, you'll realize it easily because the switches will only move in one direction rather than two.

good luck!