|
The pics below might offer some insight into Peter's description. Don't take the screw completely out when removing the ashtray wood cover - just loosen it enought to slide it up and out.
The directions below indicate screws 5 and 6 are allen. I'm almost sure they are torque, at least on my older w140.
1) on selector lever console
press up and out with plastic wedge.
Ashtray housing
open.
Ashtray insert (2)
remove.
Screw (3) in ashtray housing
loosen with offset screwdriver.
Wood cover (4)
remove upward.
Screws (5 and 6)
screw out (Allen wrench WAF 4 mm , 2.5 Nm ).
Cover (7)
press toward rear and lift at front. Then pry out cover toward front and up.
NOTE: Danger of damage, do not use sharp tools!
Plug connector on switch
disconnect.
Cover (7)
lay down.
Reinstall
in opposite order.
Removal and Installation
1 Press frame on selector lever console upward and out with plastic wedge
2 Open ashtray housing and remove ashtray insert.
3 Loosen screws (arrow) in ashtray housing with offset screwdriver.
4 Remove wooden cover (4) upward.
5 Screw out screws (arrows), (Allen wrench WAF 4 mm , 2.5 Nm ).
6 Press cover toward rear and lift at front. Then pry Out cover toward front and up.
7 Disconnect plug connector on switch.
8 Reinstall in opposite order.
__________________
Russell McMahon
Tulsa, OK
2001 CLK 320
1992 400se
1993 400e
2000 320ML
Last edited by rsmcmahon; 04-07-2006 at 11:13 PM.
|