Quote:
|
Originally Posted by Mismost
Just to be real clear...there are two lines going to the black box on the valve cover, plug those two lines. The line running from behind the IP pump to tranny should NOT BE PLUGGED.
Clean out that dash pot/orifice, mines a little round green one, just run a very small drill bit or needle through it.
|
There are three lines running to the black box.
One is the vacuum supply line that runs from a "T" near the IP. Remove this line, remove the "T" and connect the remaining two lines with a short section of vacuum hose.
One is a vent line that runs to a second "T" near the IP. Again, remove the line, remove the "T" and connect the remaining two lines with a short section of vacuum hose.
The third line is the EGR line and it runs to the temperature switch on the right side of the head. Just remove it completely.