Yes that i the one I have 5m alen wrench cap screw. I failed to hit it, and I may have loosened it to assure a good fitment. any hoo it fell off and I lost the clamp/nut and outer bearing.

I used the old race to install. Do the new outer bearing sit flush with the hub? and the grease seal also? I noticed that both seemed to be about an milimeter so from being flush inside the hub. .. in other words it seemed they should have been set further in, but I am confident that I seated them all the way down. perhaps I got a set that was not quite what I ordered, as the grease seal was too big a circumference (had to reuse the old one) and the new grease cap was too small. maybe the folks who sold the bearing to me sold the wrong set??? I bought from a different vendor this time.
thanks for your knowledge and assistance, and I'll smack it this time with a mallet (wood,. I have one).
thom