Quote:
Originally Posted by Ron in SC
Compressor is Denso 7SB16C. Vehicle is an ML 320 compressor is same as on W140 chassis.
How to remove? 10mm bolt on front is off. To I need puller, pry off, take off front part then pulley or all at same time. Not sure how to proceed.
Any hints?
|
I just replaced mine on my '99 E300. The shaft is splined. Sounds like you have a bit of light corrosion between the hub and the shaft. Try a putty knife working around the circumference of the hub/pully gap. Also watch for the shims that will try and fall out when you get the hub off.
Have you verified that the compressor isn't shot?