View Single Post
  #3  
Old 10-29-2006, 06:19 PM
whunter's Avatar
whunter whunter is offline
Moderator
 
Join Date: Dec 2003
Location: Metro Detroit, Michigan
Posts: 17,434
Answer:

Quote:
Originally Posted by basafa View Post
I own a 95 S420 for 7 years.
2 years ago the car sat in the garage for about 5 weeks, when I tried to start the car, it would not start.
I charged the battery, the car started but ran rough.
When I stopped the car it would not restart.
If it sits for a while ( 30 min ), it will restart normal.
Surprisingly the check engine light is not on.
I took the car to an independent shop they scoped the car and it showed problems with the cruise control actuator, but he was not sure that this was the problem.
The car sat till last week. After purchasing a new battery I took the car to another shop.
The mechanic tried to restart the car but it would backfired and failed to start.
His diagnosis was that the throttle body actuator was bad and the distributor caps and rotors also should be changed. He suggested to also replace the camshaft position sensor.
I checked with MBZ dealer and the throttle body actuator is also referred to as cruise control actuator or E-Gas actuator.
I have read in the forums that there is a problem with wiring harness in these Mercedes models.
How would I know if the problem is the Cruise Control Actuator or the Wiring Harness?
Is there diagnostic tools that gives more information than others?
Your suggestions and advice are most appreciated.
Thank you in advance,
Where are you?
Nearest major city.

Drain the fuel, and refill with fresh fuel.
Bleed the bad fuel from the lines.
Try starting.

Evaluating Electronic Engine Controls
http://www.peachparts.com/Wikka/EngineControls

This Volvo club page has a good overview of K-Jetronic Fuel Injection
http://www.volvoclub.org.uk/tech/fuel_injection/k_jetronic.shtml


You need to be aware of this issue on your car.

MB Wiring Harness Failure
http://www.peachparts.com/shopforum/showthread.php?p=927185



Have a great day.
__________________
ASE Master Mechanic

Prototype R&D/testing:
Thermal & Aerodynamic System Engineering (TASE) Senior vehicle instrumentation technician.
Noise Vibration and Harshness (NVH).
Dynamometer.
Heat exchanger durability.
HV-A/C Climate Control.
Vehicle build.
Fleet Durability
Technical Quality Auditor.
Automotive Technical Writer

1985 300SD
1983 300D

https://www.boldegoist.com/
Reply With Quote